Scanning Features; Scan Mode; Scanning Active Time - Datalogic RIDA DBT6400 Product Reference Manual

Pocket handheld imager scanner with bluetooth wireless technology
Hide thumbs Also See for RIDA DBT6400:
Table of Contents

Advertisement

References

Scanning Features

Scan Mode

Selects the scan operating mode for the reader. Selections are:
Trigger Single:
following occurs:
This mode is associated with typical handheld reader operation: when the trig-
ger is pulled, scanning starts and the product scans until the trigger is released,
or a label is read, or the maximum
Trigger Hold Multiple :
scans until the trigger is released or
label does not disable scanning.
ple reads of the same label while in this mode.
Trigger Pulse Multiple:
vated until
pulled again.
same label while in this mode.

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 =
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING on
5. Scan the appropriate three digits from the keypad in
NOTE
246
When the trigger is pulled, scanning is activated until one of the
Scanning Active Time
has elapsed
a label has been read
the trigger is released
When the trigger is pulled, scanning starts and the product
When the trigger is pulled, continuous scanning is acti-
Scanning Active Time
Double Read Timeout
000, 5 = 005, 20 = 020, etc.
ming Mode.
that represent the duration which was determined in the steps above. You
will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
Scanning Active Time
Scanning Active Time
Double Read Timeout
has elapsed or the trigger has been released and
prevents undesired multiple reads of the
has elapsed.
has elapsed. Reading a
prevents undesired multi-
page
103.
Appendix D, Keypad
RIDA™ DBT6400

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents