Maxicode Length Control - Datalogic RIDA DBT6400 Product Reference Manual

Enter/Exit Programming Mode

Maxicode Length Control

This feature specifies either variable length decoding or fixed length decoding
for this symbology.
Variable Length:
may be set.
Fixed Length:
DEFAULT
$CMXLC01(CR)
Maxicode Length Control = Fixed Length
Maxicode
Specifies one of the bar code lengths for
Length 1 is the minimum label length if in
fixed length if in Fixed Length Mode. Characters can be set from 0001 to 0145
characters in increments of 0001 (pad with zeroes).
See page 248
$CMXL1
Select Maxicode Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
206
For variable length decoding, a minimum and maximum length
For fixed length decoding, two different lengths may be set.
Set Length 1
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
$CMXLC00(CR)
Maxicode Length Control = Variable Length
Maxicode Length Control on page
Variable Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
CANCEL
Maxicode
206.
Mode, or the first
representing your
RIDA™ DBT6400