Enter/Exit Programming Mode
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The
selectable range for this feature is from 0 to 99 seconds. See
on page 234 for more detailed programming instructions.
Set Intercode Delay
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
60
$CKBID
00 = No Wedge Intercode Delay
DEFAULT
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
Intercode Delay
"Intercode Delay"
Appendix D, Keypad
~
RIDA™ DBT6400