Intercode Delay - Datalogic RIDA DBT6400 Product Reference Manual

References
STEP ACTION
1 Desired Setting
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The
selectable range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 =
3. Go to
4. Scan the bar code: SELECT INTERCODE DELAY SETTING on
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set
this feature.
Table 10. Wedge Intercode Delay Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
234
EXAMPLES
50ms
'0' and '5'
00, 5 = 05, 20 = 20, etc
page 60 and scan the ENTER/EXIT PROGRAMMING MODE bar code to
enter Programming Mode.
represent the duration which was determined in the steps above. You will
hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again at
the beginning.
Mode.
EXAMPLES
No Delay
00
'0' and '0'
150ms 600ms
'1' and '5' '6' and '0'
Appendix D,
5 Seconds 60 Seconds
05 60
'0' and '5' '6' and '0'
850ms
'8' and '5'
page 60.
Keypad, that
99 Seconds
99
'9' and '9'
RIDA™ DBT6400