Datalogic RIDA DBT6400 Product Reference Manual page 239

Disable Character
Specifies the value of the RS-232 host command used to disable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected.
NOTE
To set the value:
1. Determine the desired character or value. A setting of 0xFF indicates the
Disable Character is not used (not available).
2. Use the
find the hex equivalent for the desired character/value.
3. Go to
enter Programming Mode.
4. Scan the bar code: SELECT DISABLE CHARACTER SETTING on
5. Scan the appropriate two alphanumeric characters from the keypad in
Appendix D,
above. The second character will cause a two-beep indication.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
This completes the procedure. See the table below for examples of how to set
this feature.
Table 7. Disable Character Setting Examples
STEP ACTION
1 Desired character/value
Hex equivalent from ASCII
2
Chart on page 303
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT DISABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
ASCII Chart on page 303
page 31 and scan the ENTER/EXIT PROGRAMMING MODE bar code to
Keypad, that represent the desired character/value determined
EXAMPLES
'd'
0x64
'6' and '4'
on the inside back cover of this manual to
'}' 'D'
0x7D 0x44
'7' and 'D' '4' and '4'
Serial Parameters
page 31.
Disable Command
Not Used
0xFF
'F' and 'F'
231