Enter/Exit Programming Mode
Standard 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for
Control on page
on page 167
Mode. Length includes the bar code's check and data characters.
The length can be set from 1 to 50 characters. See
for more detailed programming instructions.
Select Standard 2 of 5 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
168
167. Length 1 is the minimum label length if in
Mode, or the first fixed length if in
$CS2L1
08 = Length 1 is 8 Characters
DEFAULT
Standard 2 of 5 Length
Fixed Length on page 167
"Set Length 1"
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
CANCEL
Standard 2 of 5
Variable Length
on page 248
Appendix D, Key-
~
RIDA™ DBT6400