Select Audio Jingle For Power-Up Event - Datalogic RIDA DBT6400 Product Reference Manual

Reading Parameters

Select Audio Jingle for Power-up Event

Selects which preloaded Jingle to use to indicate scanner power-up.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin™ configuration utility, use this setting to specify which of the Jingles
(1-15) or the built-in sound will be used to indicate scanner power-up. The
built-in (default) sound for power-up is Dialtone.wav
$CAUPW
Select Audio Jingle on Power-up
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
Product Reference Guide
Audio Jingles must be enabled (using the previous option) for this selec-
tion to take effect.
NOTE
The capability to download Audio jingle require Datalogic Aladdin™ configu-
ration software, for this reason it is possible only if the reader is used with
the base station.
NOTE
Enter/Exit Programming Mode
.
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT bar code again.
CANCEL
00 = Use built-in power-up sound
Appendix D,
~
83