Table of Contents
Advertisement
Reading Parameters
Good Read LED Color
Specifies the color of the RGB Good Read LED .
$CRBCL01
Good Read LED Color = Green
RGB Good Read Raising Time
Specifies the time it will take for the RGB good read to change the status from
an Off state to Brightness state.
See
"RGB Good Read Raising/Falling Time"
ming instructions.
Set RGB Good Read Raising Time
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
$CRBRT
00 = No time
DEFAULT
Enter/Exit Programming Mode
$CRBCL00
Good Read LED Color = Red
DEFAULT
$CRBCL02
Good Read LED Color = Blue
on page 238 for more detailed program-
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
representing your desired character(s). End by
Keypad
scanning the ENTER/EXIT bar code again.
CANCEL
Appendix D,
~
77
Advertisement
Table of Contents
