Insert Transfer Unit - Xerox Phaser 6280 Service Manual

Error Messages and Codes

Insert Transfer Unit

Applicable Chain Link
Initial Actions
3-70
The printer does not detect the Transfer Unit.
Chain Link 094-910: Insert Transfer Unit
Remove and reseat the Transfer Unit.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover Harness, PL1.2.11
Transfer Unit, PL4.1.1
MCU Board, PL9.1.20
Right Side Harness, PL10.1.15
Troubleshooting Procedure Table
Step Actions and Questions
1. Is the Transfer Unit installed correctly?
1
2. Is the Transfer Unit correctly installed?
Does the error still occur?
2
1. Check the wiring harness connectors P/
3
J27, P/J272, and P/J2721 between the
MCU Board and the Transfer Unit.
2. Are the connectors securely connected?
4 Check the Right Side Harness for continuity.
1. Disconnect P/J27 from the MCU Board
and P/J272 from the Front Cover
Harness.
2. Check continuity between P/J27 <=> P/
J272.
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-9
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Xerographic" on page 10-30
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
Phaser 6280 Color Laser Printer Service Manual
No
Reseat the
Transfer Unit
(page 8-8).
Complete.
Reconnect
the
connectors.
Replace the
Right Side
Harness.