Supplementary Services Parameters; Caller Id Parameters - AudioCodes Mediant 1000B User Manual

User's Manual
Parameter
Digit To Ignore Digit Pattern
configure voip > gateway voice-mail-
setting > dig-to-ignore-dig-pattern
[DigitPatternDigitToIgnore]

65.10.5 Supplementary Services Parameters

This subsection describes the device's supplementary telephony services parameters.
65.10.5.1

Caller ID Parameters

The caller ID parameters are described in the table below.
Parameter
Caller ID Permissions Table
Caller ID Permissions
configure voip > gateway dtmf-
supp-service supp-service-settings
> enable-caller-id
[EnableCallerID]
Caller Display Information Table
Caller Display Information
configure voip > gateway analog
caller-display-info
[CallerDisplayInfo]
Version 7.2
Defines a digit pattern that if received as Src (S) or Redirect
(R) numbers is ignored and not added to that number.
The valid range is a 25-character string.
Table 65-42: Caller ID Parameters
This table parameter enables (per port) Caller ID generation
(FXS interfaces) and detection (FXO interfaces).
The format of the ini file table parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index = EnableCallerID_IsEnabled,
EnableCallerID_Module, EnableCallerID_Port;
[\EnableCallerID]
Where,

Module = Module number, where 1 denotes the module in
Slot 1.

Port = Port number, where 1 denotes Port 1 of a module.
For example:
EnableCallerID 0 = 1,3,1; (caller ID enabled on Port 1 of Module
3)
EnableCallerID 1 = 0,3,2; (caller ID disabled on Port 2 of Module
3)
For more information, see Configuring Caller ID Permissions on
page 626.
Note:

The indexing of the parameter starts at 0.

The parameter is applicable only to analog interfaces.
This table parameter enables the device to send Caller ID
information to the IP side when a call is made. The called party
can use this information for caller identification. The information
configured in this table is sent in the SIP INVITE message's
From header.
The format of the ini file table parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index =
CallerDisplayInfo_DisplayString,
1125
65. Configuration Parameters Reference
Description
Description
Mediant 1000B Gateway & E-SBC