Supplementary Services Parameters - AudioCodes Mediant 600 User Manual

Parameter
Web: Internal Call Digit Pattern
EMS: Digit Pattern Internal Call
[DigitPatternInternalCall]
Web: External Call Digit Pattern
EMS: Digit Pattern External Call
[DigitPatternExternalCall]
Web: Disconnect Call Digit Pattern
EMS: Tel Disconnect Code
[TelDisconnectCode]
Web: Digit To Ignore Digit Pattern
EMS: Digit To Ignore
[DigitPatternDigitToIgnore]

13.12.5 Supplementary Services Parameters

This subsection describes the device's supplementary telephony services parameters.
13.12.5.1 Caller ID Parameters
The caller ID parameters are described in the table below.
Parameter
Web: Caller ID Permissions Table
EMS: SIP Endpoints > Caller ID
[EnableCallerID]
SIP User's Manual
Determines the digit pattern used by the PBX to indicate
an internal call.
The valid range is a 120-character string.
Determines the digit pattern used by the PBX to indicate
an external call.
The valid range is a 120-character string.
Determines a digit pattern that when received from the Tel
side, indicates the device to disconnect the call.
The valid range is a 25-character string.
A digit pattern that if received as Src (S) or Redirect (R)
numbers is ignored and not added to that number.
The valid range is a 25-character string.
Table 13-41: Caller ID Parameters
This ini file table parameter configures Caller ID permissions. It
allows you to enable or disable (per port) Caller ID generation
(for FXS interfaces) and detection (for FXO interfaces).
The format of this parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index = EnableCallerID_IsEnabled,
EnableCallerID_Module, EnableCallerID_Port;
[\EnableCallerID]
Where,

IsEnabled:

[0] Disable = disables Caller ID (default).

[1] Enable = enables Caller ID generation (FXS) or
detection (FXO).

Module = Module number (where 1 depicts the module in
Slot 1).

Port = Port number (where 1 depicts Port 1 of a module).
For example:
EnableCallerID 0 = 1,3,1; (caller ID enabled on Port 1 of
Module 3)
EnableCallerID 1 = 0,3,2; (caller ID disabled on Port 2 of
Module 3)
Notes:
614
Mediant 600 & Mediant 1000
Description
Description
Document #: LTRT-83308