Verify The Main Module - Oracle SPARC T8-4 Service Manual

a. Configure the SER MGT port to enable the firmware image to be
downloaded.
Refer to the Oracle ILOM documentation for network configuration instructions.
b. Download the system firmware.
Follow the firmware download instructions in the Oracle ILOM documentation.
You can load any supported system firmware version, including the firmware revision
Note -
that had been installed prior to the replacement of the main module. However, Oracle strongly
recommends installing the newest version of the system firmware.
c. Restore the ILOM configuration settings.
Refer to the
Power on the server.
8.
See "Returning the Server to Operation" on page
Related Information
"Main Module Components" on page 20
■
"Main Module LEDs" on page 98
■
"Remove the Main Module" on page 99
■

Verify the Main Module

Verify that the main module Service Required LED is not lit.
1.
See "Main Module LEDs" on page
2. Verify that the front and rear System Service Required LEDs are not lit.
See "Front Panel Controls and LEDs" on page 29
LEDs" on page
3. Consider these options.
If the previous steps did not clear the fault, see
■
If the previous steps indicate that no faults have been detected, then the main module has
■
been replaced successfully. No further action is required.
ILOM documentation (http://www.oracle.com/goto/ilom/docs).
98.
30.
191.
and "Rear Panel Controls and
"Diagnostics Process" on page
Servicing the Main Module
Verify the Main Module
26.
105