Table of Contents
Advertisement
Chapter 4: Setup
13.
Verify Job Settings
Test the job settings, using the Pick Part and Place Part buttons to pick and
place parts. If adjustments are required, use the left Arrow key to return to the
desired step and adjust settings. Press the right Arrow Key to move to the next
Job Wizard screen.
Note: Manually placed parts will be counted in the current job.
14.
Vision Settings
a. Set Camera State to ON ( I ) or OFF (O).
b. If camera is enabled, enter number of Parts Until Inspection (do not include
part at Pick point.). Press the right Arrow Key to move to the final Job Wizard
screen
D292104.7a.fm
4- 25
Configure HMI Settings
Advertisement
Table of Contents
