Table of Contents
Advertisement
Chapter 7: Troubleshooting
Low Cover Tape System Alarm
The Low Cover Tape sensor is located on the Cover Tape Arm. It
detects when the cover tape supply on the Cover Tape Reel is
below a preset minimum.
If an operator attempts to start a job when the cover tape level is
below the sensor, operation will not begin. Instead a beep will
sound and a Low Cover Warning message will appear on the
HMI.
The operator can either resolve the warning by loading a full reel of cover tape or ignore the
warning and push START again to continue with the current level of cover tape.
Note: The Low Cover Tape warning will only appear once during a job. If the user ignores
the message and continues operation, the TM-401 will continue taping until the job is fin-
ished or the cover tape is empty.
D292104.9a.fm
7-15
System Alarm Messages
Advertisement
Table of Contents
