Table of Contents
Advertisement
Chapter 3: Human Machine Interface
In the photo below, a part is shown at the pick position as viewed from the front of
the machine.
• If rotation is set at 0, the part will be placed in the same orientation as it was
picked.
• If rotation is set at -90, the part will be rotated 90 degrees clockwise prior to
placement.
• If rotation is set at +90, the part will be rotated 90 degrees counter-clockwise
prior to placement.
Press the right Arrow Key to move to the next Job Wizard screen.
Job Wizard Step 13
A.
Test the job settings, using the Pick Part and Place Part buttons to pick and place
parts.
B.
If adjustment are required, use the left Arrow key to return to the desired step and
adjust settings until the TM-401 picks and places parts as desired,
D292104.6.fm
Rotation Options
-90
0
+90
3-15
Job Tab
Advertisement
Table of Contents
