Table of Contents
Advertisement
Chapter 7: Troubleshooting
Error Condition
"The system is currently in a
halted state."
"The HMI is in an error condi-
tion..."
D292104.9a.fm
Check the following:
- The Emergency Stop has been pressed. Resolve the
situation, then twist and release the. E-Stop button.
- The Reset Button has not been pressed. Press Reset.
- Once the condition is corrected, wait for system initial-
ization and home all motors.
- If an unacceptable value has been entered into a setup
field, change the value to one that fits that field's parame-
ters.
- If this message persists, the Ethernet connection to the
PLC may have been lost. Contact V-TEK Service for sup-
port.
Solution
System Alarm Messages
7-21
Advertisement
Table of Contents
