Table of Contents
Advertisement
Chapter 1: Assembly & Installation
b. The Carrier Tape Arm has a dowel pin which locks into position holes on the Track
Support Bracket. Slide the Carrier Tape Arm onto the threaded rod, engage the dowel pin
into the desired position, and secure it into place with the black knob.
4.
Positioning the Take-up Arm
a. The Take-up Arm has a dowel pin which
locks into position holes on the Track Sup-
port Bracket. Loosen the black knob on the
back of the Take-up Arm and position it at
about a 45 degree angle from the baseplate
assembly. Engage the dowel pin into the
desired position and secure it into place with
the black knob..
b. Plug the electrical connector into the
take-up motor receptacle.
D292104.4.fm
Knob
Position Holes
1- 9
Assembling the TM-401
Advertisement
Table of Contents
