V-TEK TM-401 User Manual page 166

7-8 TM-401 User's Guide
Part Lost System Alarm
If a part falls off the nozzle and is lost during the Pick process, the Part Lost system alarm will be
activated. When this happens, operation stops, a beep sounds, and a warning appears on the
HMI.
To clear the Part Lost System Alarm, check the Vacuum Sensor to ensure it is set correctly. Next,
ensure the correct Nozzle Tip for the part that is being picked is installed. Finally, check the Pick
Position to ensure it is centered correctly. Adjust as necessary.
When the Tube Feeder is ready for operation, press CONTINUE to clear the alarm and resume
operation.
System Alarm Messages D292104.9a.fm