Table of Contents
Advertisement
Chapter 5: Setup
Connect Vision
Step 1:
Vision
Setup
CONNECT
If vision is enabled for a job, the vision computer/monitor must be connected to the Key-
ence IV-G Camera and the camera must be trained to inspect the part before the job can
be run.
Setup HMI
Follow the steps below to enable Vision Inspection on the TM-401.
1.
On the TM-401 HMI, open the Taper Tab. Press the right Arrow button to advance
to the second Taper screen. .Ensure the Camera State is set to ON ( I )
2.
Using the M12 ethernet cable which was provided with the TM-401 system,
connect the vision computer to the Keyence camera.
D292104.16.fm
Note: The TM-401 vision system can be run with a computer or a Keyence IV-G
Monitor. These options are not included with the TM-401. They can be purchased
separately from V-TEK, Inc. or the user may provide their own computer.
System requirements for the vision computer follow:
• Operating system: Microsoft® Windows XP
TM
or Windows 7
(32 or 64 bit)
• 128 MB RAM
• 1024 x 768 (96 DPI) or 1280 x 1024 (120 DPI display
• Ethernet port
TM
(32 bit), Windows Vista
5- 3
TM
(32bit),
Connect Vision
Advertisement
Table of Contents
