Table of Contents
Advertisement
Chapter 4: Setup
Load the Manual Tube Input Device (MTID)
Step 3:
Load the
MTID
The MTID must be loaded with tubes and config-
ured for operation. Begin by preparing the MTID,
then move to the HMI to adjust settings as
needed (Step 6). Follow the directions below to
setup the Tube Feeder.
1.
Ensure the correct tooling for the selected
part is installed on the feeder. If new
tooling needs to be loaded, follow the
steps below to change tooling
A. Remove all tubes from the feeder,
plugging the end of the tubes before
removal.
B. Using a 9/64' Hex wrench, remove the
(2) socket head cap screws in the Tooling
Platform.
C. Remove the Tooling Platform.
D. Insert the correct Tooling Platform,
positioning it on the dowel pins to ensure
correct placement.
E. Insert the (2) socket head cap screws
and tighten in place.
2.
Loosen the Clamping Bolts on the bottom of the MTID and move the Slotted Plate
so the Pick Area is centered under the Nozzle.
Note: For longer parts, the Feeder will need to be positioned closer to the Pick
Head Bridge. For shorter parts, move the Feeder closer to the Enclosure Doors.
D292104.7a.fm
Adjust Feeder position on Slotted Plate
Y Axis Clamping Bolts
Load the Manual Tube Input Device (MTID)
4- 5
Advertisement
Table of Contents
