Quick Start: Setup - V-TEK TM-401 User Manual

4-2

Quick Start: Setup

The following is an outline of the basic steps required to setup the TM-401 for operation.
More detailed instructions follow in the next section of this chapter.
1. Power up
• Power up the machine. Press Reset. Close all doors.
2. Home the motors
• Press Home Required and Home All Motors.
3. Load the Manual Tube Input Device (MTID)
• Ensure the correct Tooling for the part size to be processed is installed.
• Load components into the Tube Feeder.
4. Install Nozzle
• Ensure correct nozzle size and tip are installed.
5. Load Taper
• Load carrier tape.
• Load cover tape.
• Place an empty reel on the Take-up Arm.
6. Configure HMI settings
• Go to the Job Tab and run the Job Wizard to configure job settings.
7. Test Sealer
• Perform a Seal Test to ensure a good seal, adjust Sealer settings as necessary.
8. Setup 2D Vision
• Connect Vision Computer
• Setup 2D Vision Inspection.

Quick Start: Setup

Caution: Users should always wear protective eye wear when operat-
ing or maintaining the TM-401.
TM-401 User's Guide
D292104.7a.fm