Table of Contents
Advertisement
Chapter 7: Troubleshooting
Note: There are a variety of error conditions which could cause the machine to stop. See
the Error Message Table at the end of this section for an explanation of the various error
messages and their suggested solutions.
An illustration and description of each System Alarm Message follows.
Unable to Pick System Alarm
If the nozzle is unable to pick a part from the Tube Feeder, the Unable to Pick system alarm will
be activated. When this happens, operation stops, a beep sounds, and a warning appears on the
HMI.
To clear the Unable to Pick Alarm, ensure there are parts in the feeder and it is feeding properly
with no jams in the feeding track. If that does not resolve the problem, ensure the Pick Height is
not set too high. Finally, verify the Vibratory is ON.
When the Tube Feeder is ready for operation, press CONTINUE to clear the alarm and resume
operation.
D292104.9a.fm
7-7
System Alarm Messages
Advertisement
Table of Contents
