Table of Contents
Advertisement
3-26
MTID Tab
The Manual Tube Input Device (MTID) Setup Tab allows the user to set the number of tubes and
utilize the Pitch Wizard to calculate pick position..
A.
Press any tab in the Tab Menu to open that tab window.
B.
Number Of Tubes To Process is the number of tubes that have been loaded into
the tube feeder.
Number Of Tracks Per Feeder is the total number of tubes that can be pro-
cessed by a single tube feeder. For example, if the system has two Tube Feeders
that are equipped with eight track tooling, the Total Number Of Tubes would be
eight. However, the Number Of Tubes To Process could be as high as 16.
Note: The MTID does not need to be fully loaded to operate. However, if If only one tube
is loaded, enter a 2 for the number of tubes. If there are consecutive miss-picks, the TM-
401 will always attempt to pick a second tube and then return to the original tube allowing
Tube 1 to feed properly.
MTID Tab
A
B
A. Tab Menu
B. Number of Tubes Fields
C. Pitch Wizard button
TM-401 User's Guide
C
D292104.6.fm
Advertisement
Table of Contents
