Assembling The Tm-401; Equipment Required - V-TEK TM-401 User Manual

1-6

Assembling the TM-401

Equipment Required

• Adjustable wrench (needs to fit 1 1/16" to 1 3/32" nut)
• Hex wrench set (provided with machine)
• 85-110 PSI air pressure system
Note: Read the TM-401 User's Guide before assembling the TM-401.
Unpack the TM-401 Crate
1. Move the Crate to the Work Area. Use a fork lift to move the TM-401 crate to the pre-
pared work area. Ensure the fork is centered under the crate before lifting.
Note: Use a forklift with a minimum load capacity of 300 pounds (136 kg) and a fork
length that is a minimum of 35 inches (89 cm) so the fork fully extends beyond the crate
on the other side. The forklift should only be operated by a licensed/certified operator.
2, Unpack the Crate.
a. Remove the top and sides from the TM-
401 crate. Set aside.
b. The TM-401 is shipped partially disas-
sembled, with the Tower Light, Take-up
Arm and Carrier Tape/Feed Arm detached
and wrapped in bubble wrap. Remove the
smaller items one at a time from the crate
and place on a flat, stable surface for
assembly.
c. Remove and discard the protective wrapping from each part.
3. Remove the TM-401 from the Crate.
a. The TM-401 is bolted to the bottom of the crate for shipping. Reach below the crate to
unfasten the bolts.
Note: If the optional 80/20 Frame was purchased, follow the assembly instructions in the
80/20 Frame Exploded Views document which can be found in the Exploded Views sec-
tion at the end of this manual before proceeding.
Assembling the TM-401
TM-401 User's Guide
D292104.4.fm