Table of Contents
Advertisement
3-14
Press the right Arrow Key to move to the next Job Wizard screen..
Job Wizard Step 11
A.
Press Place Extend to lower the Nozzle to the Carrier Tape Pocket.
Follow the directions in Chapter 4: Setup for manually adjusting the place Actuator
to set the correct Nozzle Height at the Place position.
Press the right Arrow Key to move to the next Job Wizard screen.
Job Wizard Step 12
A.
Enter the placement angle which was manually set in Step 8. The options are 0, -
90 and +90.
Job Tab
A
Note: The Place Extend button toggles between Place Extend and Place
Retract. Once Place Extend has been pressed, the button will change to
Place Retract.
TM-401 User's Guide
A
D292104.6.fm
Advertisement
Table of Contents
