Table of Contents
Advertisement
Chapter 6: Operation
Run the Job
Step 8:
Run
1.
Close the enclosure doors, then open the HMI Run Tab and press Run.
Job
During operation, the operator will add additional parts to the Tape Feeder and
unload packaged parts from the Taper as necessary. The operator may also
replace parts that fail 2D Inspection. Otherwise no other adjustments are required
for a job that has already been defined properly.
2.
When the preset number of parts has been run, the TM-401 will automatically stop
operation.
3.
Cut the sealed tape at the cut point and use a piece of blue Permacel tape to
secure the finished reel. Remove processed output.
D292104.8a.fm
Preparing to Run a Pre-programmed Job
6- 11
Advertisement
Table of Contents
