Table of Contents
Advertisement
Chapter 6: Operation
Setup the Taper
Step 4:
Setup
1.
Load the correct carrier tape and cover
Taper
tape, adjusting the track width as
necessary.
2.
Select PSA or Heat seal.
3.
Align cover tape with carrier tape.
4.
Run a pull test and adjust seal strength
as needed.
5.
Place an empty reel onto the take-up
reel spindle.
6.
Use the Continuous Advance button on the Taper Tab to run out the tape until it
can be attached to the reel.
The tape normally can be attached by inserting it into the reel hub or with adhesive
tape.
D292104.8a.fm
Preparing to Run a Pre-programmed Job
6- 7
Advertisement
Table of Contents
