Table of Contents
Advertisement
Chapter 3: Human Machine Interface
Pressing the right Arrow button in the third Taper Setup screens opens the final Taper Setup
screen. The fourth Taper Setup screen focuses on Leader and Sensor settings.
Taper Screen 4
A.
The Tape Jam Sensor ON ( I ) or OFF (O) button turns the Tape Jam Sensor on
and off. The Tape Jam Sensor registers a tape jam whenever something pro-
trudes above the top of the carrier tape pocket. This might be caused by a mis-
placed part, a pocket that has been loaded with two parts or by a buckle in the
tape.
When the Tape Jam Sensor is activated, the job that is being run is paused and an
error message appears on the HMI screen. The recommended setting for the
Tape Jam Sensor is ON.
The Low Cover Sensor ON ( I ) or OFF (O) button turns the Low Cover Tape Sen-
sor on and off. The Low Cover Tape Sensor detects when the cover tape reel is
running low. When the Low Cover Tape Sensor is activated, an error message
appears on the HMI screen. The recommended setting for the Low Cover Tape
Sensor is ON.
Note: The Low Cover error message is only displayed once during a job.
B.
When Leader State is ON ( I ), the TM-401 will create a leader of the specified
length at the end of the job.
The Leader Length field is only active when Leader State is ON. Enter the
desired leader length in millimeters in the field.
Note: The TM-401 will use these settings for the current job. To save Taper Settings for
future jobs, go to the Job Tab, select a job name and Save. If settings are not saved, all
data is lost when the TM-401 is powered off.
D292104.6.fm
A
B
3-21
Taper Tab
Advertisement
Table of Contents
