Quick Start: Running A Job - V-TEK TM-401 User Manual

6-2

Quick Start: Running a Job

Quick
Start
The following is an outline of the basic steps required to run a pre-programmed job. More
detailed instructions follow in the next section of this chapter.
1. Power up.
• Power up the machine by turning on the Main Power Switch.
• Press the Reset button.
2. Home the motors.
• Open the Run Tab on the HMI and select Home Motors.
3. Setup Manual Tube Input Device (MTID).
• Ensure the correct tooling is installed on the MTID for the components that will
• Load components.
• Turn Vibratory ON.
• Adjust Amplitude and Frequency for proper feeding.
4. Setup Taper.
• Ensure sufficient carrier tape and cover tape are loaded to complete the job.
• Load an empty take-up reel.
• Run peel force test to verify seal.
5. Setup the Pick Head.
• Ensure the correct nozzle is installed for the part that will be picked.
• Observe the vacuum sensor, adjusting nozzle pressure as necessary.
• Adjust Blow-off Pressure as needed to achieve proper part placement.
• Close the enclosure doors.

Quick Start: Running a Job

Caution: Users should always wear protective eye wear when operat-
ing or maintaining the TM-401.
be processed.
TM-401 User's Guide
D292104.8a.fm