Table of Contents
Advertisement
Chapter 3: Human Machine Interface
The Continuous Advance button advances the tape through the Taper and onto
the take-up reel. It will continue to advance until Continuous Advance is pressed
a second time.
Note: Continuous Advance is useful for creating a trailer or loading tape at the begin-
ning of a job.
Pressing the right Arrow button opens the next Taper Setup screen which focuses on Vision
Setup.
Taper Screen 2
A.
The Camera State button toggles between ON ( I ) and OFF (O).
The Parts Until Inspection value is the number of pockets between the Place
point and the Inspection point. Begin the count at the Place position at zero, so
the Place position is not included.
B.
Pressing the Trigger button triggers the 2D Camera to inspect the part which is
currently at the Inspection point. The box to the right of the Trigger button will dis-
play a green PASS message or a red FAIL message.
Note: For more detailed inspection configuration and procedures, see the Cognex
Checker User's Guide which was included with the TM-401.
Pressing the right Arrow button opens the next Taper Setup screen.
D292104.6.fm
A
B
3-19
Taper Tab
Advertisement
Table of Contents
