Table of Contents
Advertisement
Chapter 6: Operation
Quick
6.
Select Job.
Start
• Open the Job Tab on the HMI. Select the desired job from the Job Library and
7.
Setup Vision.
• Open the Taper Tab on the HMI and advance to the second screen.
• Ensure camera is enabled. Configure inspection as needed.
Note: To configure vision inspection, see Chapter 4: Setup.
8.
Run the Job.
• On the HMI, select the Run Tab then press Run.
• Load/unload parts and reels as needed.
D292104.8a.fm
press Open to open the selected job in the Run Tab.
Caution!
V-TEK® Incorporated takes no responsibility for the safety of TM-401 if it is
used for any purpose other than the intended purpose as specified in this
User's Guide.
6- 3
Quick Start: Running a Job
Advertisement
Table of Contents
