Table of Contents
Advertisement
Chapter 7: Troubleshooting
5.
Adjust Blow Off Time. Press the right Arrow button on the bottom of the second Head
Tab to move to the last Head Tab screen
6.
Adjust the length of Blow Off as needed to drop the part properly.
Note: If Nozzle Blow Off is set too low, the part may remain on the Nozzle Tip or "float"
down, resulting in an incorrectly placed part in the pocket.
If Nozzle Blow Off is set too high, the excess air may cause the part to bounce back out of
the pocket. Adjust the Nozzle Blow Off value until the TM-401 consistently and accurately
places parts in the carrier tape.
D292104.9a.fm
7-25
Tips on Part Placement
Advertisement
Table of Contents
