Table of Contents
Advertisement
Chapter 7: Troubleshooting
Tips on Part Placement
If components are not dropped properly, there are four variables that can be adjusted to correct
the problem.
Note: Each part is different and may require a different combination of adjustments to
obtain proper place performance.
1.
Adjust Blow-off Pressure. The Blow-off Pressure Gauge is
located on the front of the Pick Head enclosure. If components
are not dropping properly, loosen locking nut and rotate to adjust
pressure levels. When the desired pressure level is reached,
tighten locking nut.
Note: Every part is different and may require a different combi-
nation of adjustments to obtain proper place performance.
2.
Adjust Place Position X. Open the HMI Head Tab. Press the Move To Place button.
D292104.9a.fm
7-23
Tips on Part Placement
Advertisement
Table of Contents
