Table of Contents
Advertisement
Chapter 3: Human Machine Interface
B.
Seal Type toggles between PSA and Heat seal, select correct seal type.
C.
The Set Point fields for the Inner and Outer Sealer are used to set the desired
temperature for Heat Seal. Enter the correct value in both fields, then press the
right Arrow Key to move to the next Job Wizard screen.
Note: The TM-401 accommodates a wide range of carrier tapes and cover tapes. Set-
tings may vary from one tape product to another. The recommended starting point is 90°
C. The maximum recommended operating temperature is 160°
each seal shoe should be increased or decreased as needed after running a peel force
test.
The fourth Job Wizard screen enables or disables the tape Leader.
Job Wizard Step 4
A.
Leader State toggles between ON ( I ) and OFF (O).
B.
Pressing the Leader Length field will open a keypad. Type in the desired value,
then press the right Arrow Key to move to the next Job Wizard screen.
D292104.6.fm
A
B
3-9
C.
The temperature for
Job Tab
Advertisement
Table of Contents
