V-TEK TM-401 User Manual page 54

3-12
The next six Job Wizard screens are used to set the Nozzle positions at the Pick and
Place locations. The first is shown below.
Job Wizard Step 8
A. Press Pick Extend/Pick Retract to lower the Nozzle to the tube pocket. Follow
the directions in Chapter 4: Setup for manually adjusting the Pick Actuator to set
the correct Nozzle Height.
Press the right Arrow Key to move to the next Job Wizard screen.
Job Wizard Step 9
A. Press Pick Part to activate the nozzle and pick a part.
Job Tab
A
A
B
TM-401 User's Guide
D292104.6.fm