V-TEK TM-401 User Manual page 169

Chapter 7: Troubleshooting 7-11
Vision Error System Alarm
The 2D Inspection System is mounted on the Taper between the
place point and the Sealer. It inspects parts for mark and orienta-
tion. It also detects empty pockets
If the 2D Inspection System detects an inspection error, the 2D
Inspection System Alarm will be activated. Tape advance stops,
a beep sounds and a warning appears on the HMI.
To clear the Vision Error system alarm, re-orient or replace the failed part under the 2D Inspec-
tion Camera. Press CONTINUE to clear the alarm and resume operation.
D292104.9a.fm System Alarm Messages