7-22
Adjusting Nozzle Vacuum Sensors
The TM-401's Nozzle Vacuum Sensor is setup before the machine is shipped. It may occasion-
ally require adjustment depending on vacuum sensitivity and the type of part that is being pro-
cessed.
If the TM-401 places "empty" pockets (i.e. places as though it held a part when it did not) or
returns a picking part error when it picked a part, the vacuum sensor's threshold point probably
needs to be adjusted.
Vacuum Sensor Settings
1.
Close the enclosure doors, then open the Head Setup Tab.
2.
Press the Pick Part button to activate vacuum and pick a
part. Observe the vacuum sensor indicator which is located
on the Pick & Place Head above the nozzles. The numbers
should be lit in
red
if components are not.
3.
If the sensors require adjustment, Press the blue
once. The sensor will alternately flash P_1 and the current
value.
4.
Use the Up/Down Arrow Keys to adjust the sensor as
needed with components both on and off of the nozzles.
5.
Press the blue
Set
Adjusting Nozzle Vacuum Sensors
green
with components on the nozzle and
button again to exit back to normal operation.
TM-401 User's Guide
Set
button
D292104.9a.fm