YASKAWA L1000A Technical Manual page 42

2.2 Mechanical Installation
Installation Types and Required Materials
The digital operator mounts to an enclosure two different ways:
1.
External/face-mount installs the operator outside the enclosure panel
2.
Internal/flush-mount installs the operator inside the enclosure panel
Table 2.2 Digital Operator Installation Methods and Required Tools
Installation Method
Simplified installation with the digital
External/Face-Mount operator is mounted on the outside of
the panel with two screws.
Encloses the digital operator in the
Internal/Flush-Mount panel. The digital operator is flush
with the outside of the panel.
NOTICE: revent foreign matter such as metal shavings or wire clippings from falling into the drive during installation and project
construction. Failure to comply could result in damage to the drive. Place a temporary cover over the top of the drive during installation.
Remove the temporary cover before drive start-up, as the cover will reduce ventilation and cause the drive to overheat.
External/Face-Mount
1.
Cut an opening in the enclosure panel for the digital operator as shown in
2.
Position the digital operator so the display faces outwards, and mount it to the enclosure panel as shown in
Figure 2.7.
Figure 2.6
Figure 2.7
42
Description Installation Support Sets
Installation Support Set A
(for mounting with screws through
Installation Support Set B
(for use with threaded studs that are
Digital Operator
Figure 2.7 External/Face-Mount Installation
Figure 2.8 Panel Cut-Out Dimensions (External/Face-Mount Installation)
–
holes in the panel)
fixed to the panel)
M3 × 6
Phillips recessed
pan head machine screw × 2
Enclosure panel
22
22
14
Unit: mm
YASKAWA ELECTRIC SIEP C710616 38A YASKAWA AC Drive L1000A Technical Manual
Model Required Tools
– Phillips screwdriver (#1)
EZZ020642A Phillips screwdriver (#1, #2)
Phillips screwdriver (#1)
EZZ020642B
Figure 2.8.
common_TMonly
Unit: mm
common_TMonly
Wrench (7 mm)