Monitored Data; Operation Principle; Selector Mini Switch Vsggio; Identification - ABB REC650 Technical Manual

1MRK 511 287-UEN A
10.5.6
10.5.7
10.6
10.6.1
Technical manual

Monitored data

Table 230: SLGGIO Monitored data
Name Type
SWPOSN INTEGER

Operation principle

The logic rotating switch for function selection and LHMI presentation (SLGGIO)
function has two operating inputs – UP and DOWN. When a signal is received on the
UP input, the block will activate the output next to the present activated output, in
ascending order (if the present activated output is 3 – for example and one operates the
UP input, then the output 4 will be activated). When a signal is received on the DOWN
input, the block will activate the output next to the present activated output, in
descending order (if the present activated output is 3 – for example and one operates
the DOWN input, then the output 2 will be activated). Depending on the output
settings the output signals can be steady or pulsed. In case of steady signals, in case of
UP or DOWN operation, the previously active output will be deactivated. Also,
depending on the settings one can have a time delay between the UP or DOWN
activation signal positive front and the output activation.
Besides the inputs visible in the application configuration in the Application
Configuration tool, there are other possibilities that will allow an user to set the desired
position directly (without activating the intermediate positions), either locally or
remotely, using a "select before execute" dialog. One can block the function
operation, by activating the BLOCK input. In this case, the present position will be
kept and further operation will be blocked. The operator place (local or remote) is
specified through the PSTO input. If any operation is allowed the signal INTONE
from the Fixed signal function block can be connected. SLGGIO function block has
also an integer value output, that generates the actual position number. The positions
and the block names are fully settable by the user. These names will appear in the
menu, so the user can see the position names instead of a number.

Selector mini switch VSGGIO

Identification

Function description
Selector mini switch
Values (Range) Unit
- -
IEC 61850 IEC 60617
identification identification
VSGGIO -
Section 10
Control
Description
Switch position as integer
value
ANSI/IEEE C37.2
device number
-
325