Pulse Timer Function Block Pulstimerqt - ABB REC650 Technical Manual

Section 11
Logic
11.3.2.4
Table 297: PULSETIMERQT Non group settings (basic)
Name
t
362

Pulse timer function block PULSTIMERQT

Identification
Function description
Pulse timer function block
Functionality
Pulse timer function block (PULSETIMERQT) can be used, for example, for pulse
extensions or limiting of operation of outputs. The pulse timer has a settable length
and will also propagate quality and time.
When the input goes to 1 the output will be 1 for the time set by the time delay
parameter t. Then return to 0.
When the output changes value, the timestamp of the output signal is updated.
The supported "quality" state bits are propagated from the input each execution to the
output. A change of these bits will not lead to an updated timestamp on the output.
Function block
PULSETIMERQT
INPUT
IEC09000304-1-en.vsd
IEC09000304 V1 EN
Figure 180: PULSETIMERQT function block
Signals
Table 295: PULSETIMERQT Input signals
Name
INPUT
Table 296: PULSETIMERQT Output signals
Name
OUT
Settings
Values (Range) Unit
0.000 - 90000.000 s
IEC 61850
identification
PULSTIMERQT
OUT
Type Default Description
BOOLEAN 0 Input signal
Type Description
BOOLEAN Output signal
Step Default
0.001 0.010
1MRK 511 287-UEN A
IEC 60617 ANSI/IEEE C37.2
identification device number
- -
Description
Pulse time length
Technical manual