Replacing Tfm; Preliminary Steps - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

"Updating RAID controller firmware" on page 90
Ê
"Enabling SVOM boot watchdog functionality" on page 94
Ê
"Switching on the server" on page 75
Ê
"Enabling BitLocker functionality" on page 100
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable,"After replacing / upgrading LAN controllers" on page
9.4.4

Replacing TFM

Upgrade and Repair Unit
(URU)
Tools: Phillips PH1 / (+) No. 1 screw driver
9.4.4.1

Preliminary steps

"Locating the defective server" on page 47
Ê
"Shutting down the server" on page 50
Ê
"Disconnecting the server from the mains" on page 50
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 51
Ê
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section
page 421.
TX150 S8 / TX200 S7
219.
"Onboard indicators and controls" on
Upgrade and Maintenance Manual
Expansion cards and backup units
"Note on network
Hardware: 5 minutes
104.
221