Table of Contents
Advertisement
Chapter 5 CLI
❑: Parameter
Parameter
1. Server power
2. Set Server Maximum Restart
Retries
3. Set Server Boot Mode
98
Setting
❑
Power On
Sets Server Blade power supply.
❑
graceful
When using, refer to "6.2 Points to Note about Remote
shutdown and off
Power OFF and the Shutdown Function" ( p.139).
❑
graceful
• Power On
shutdown and
Turns the server on.
power-cycle
• graceful shutdown and off
❑
hard reset
Turns off power after shutting down the OS using the
❑
NMI
ServerView agent operating on the Server Blade.
❑
Hard Power off
• graceful shutdown and power-cycle
Turns power on again after turning off power and
shutting down the OS using the ServerView agent
operating on the Server Blade.
• hard reset
Reboots the Server Blade.
• NMI
Do not normally select.
• Hard Power off
The Server Blade is forcibly turned OFF.
Important:
When using this function, it is necessary to make various settings to
Server Blades. For details, refer to "6.2 Points to Note about
Remote Power OFF and the Shutdown Function" ( p.139). Do not
select when performing operations for Server Blades that are not
supported because there is a fear that unexpected operations such
as ACPI shutdown or power off may occur.
Remarks:
When ordering power on after ordering Server Blade power off,
check the power has been turned off correctly.
❑
0 – 7
Sets how many times will be retried after OS start fails.
If set to 0, retry will not be performed.
❑
normal
Sets the boot method for Server Blade OS boot.
❑
pxe-lan-1
• normal
❑
pxe-lan-2
Sets the boot order of Server Blade to the default
❑
pxe-lan-3
settings set in BIOS.
❑
• pxe-lan-1 – pxe-lan-6
pxe-lan-4
❑
pxe-lan-5
Set the selected LAN port to the top priority of the
❑
pxe-lan-6
Server Blade boot order and change so that it boots in
❑
add-in-pci-lan-1
Preboot eXecution Environment (PXE).
❑
add-in-pci-lan-2
• add-in-pci-lan-1 / add-in-pci-lan-2
Set LAN port 1 or 2 installed in the expansion card
slot module to the top priority of the Server Blade boot
order and change so that it Preboot eXecution
Environment (PXE).
Note:
When installing expansion cards other than a LAN card, if "add-
inpci-lan-1" or "add-in-pci-lan-2" is selected the Server Blade will
stop in the middle of boot. If this happens, turn off the Server Blade,
change the boot mode and then turn the power on again.
Contents
Advertisement
Table of Contents
