PRIMERGY BX600 S3 Hardware Manual page 73

●
12. Agent HTTP (1_1_12)
Sets the HTTP agents in the Management Blade.
+------------------------------------------+
|
+------------------------------------------+
(1) Set HTTP Enable
(2) Set HTTP Port
(3) Set HTTP SSL Enable : disable
(4) HTTP IP Filter Table
Enter selection or type (0) to quit:
❑: Parameter
Parameter
1. Set HTTP Enable
2. Set HTTP Port
3. Set HTTP SSL Enable
4. HTTP IP Filter Table
PRIMERGY BX600 Management Blade Hardware Guide
Agent HTTP page_1_1_12
: enable
: 80
Setting
❑
enable Sets HTTP service enable/disable. Settings become valid
❑
disable after restarting the Management Blade.
If HTTP service is disabled Web UI cannot be used.
- Sets the port number of HTTP. These setting become valid
in 10 seconds.
❑
enable Sets whether HTTP SSL is to be used.
❑
disable
Important:
In order to use SSL, it is necessary to enable SSL version 3 only in the
Web browser. Also, if SSL version 2 is enabled in the Web browser,
change to disable.
- Performs IP settings that permit HTTP connection. A
maximum of 10 IPs that permit HTTP can be registered.
"255.255.255.255" is registered by default so it will not
perform IP filtering. It must be deleted as necessary when
performing IP filtering.
|
Contents
73