PRIMERGY BX600 S3 Hardware Manual page 77

❑
: Parameter
Parameter
1. Set Telnet Enable
2. Set Telnet Port
3. Telnet IP Filter Table
4. Telnet Disconnection
5. Set telnet SSL Enable
• 3. Telnet IP Filter Table (1_1_14_3)
Performs IP settings that permit Telnet service.
A maximum of 10 IP that permit Telnet can be registered.
255.255.255.255, that was set at the time of purchase, does not perform IP filtering. When
performing IP filtering, delete it as necessary.
+------------------------------------------+
|
Telnet IP Filter Table
+------------------------------------------+
(1) Telnet IP Filter 1 : 255.255.255.255
(2) Telnet IP Filter 2 : 0.0.0.0
(3) Telnet IP Filter 3 : 0.0.0.0
(4) Telnet IP Filter 4 : 0.0.0.0
(5) Telnet IP Filter 5 : 0.0.0.0
(6) Telnet IP Filter 6 : 0.0.0.0
(7) Telnet IP Filter 7 : 0.0.0.0
(8) Telnet IP Filter 8 : 0.0.0.0
(9) Telnet IP Filter 9 : 0.0.0.0
(10)Telnet IP Filter 10: 0.0.0.0
Enter selection or type (0) to quit:
PRIMERGY BX600 Management Blade Hardware Guide
Setting
❑
enable Sets Telnet service enable/disable. Settings become valid
❑
disable after restarting the Management Blade.
- Sets the port number of telnet.
Settings become valid after restarting the Management
Blade.
- Performs IP settings that permit Telnet service.
"• 3. Telnet IP Filter Table (1_1_14_3)" (p.77)
- The Telnet connection is forcibly turned OFF. Perform
operations following the directions on the screen.
❑
enable Sets whether Telnet SSL is to be used.
❑
disable
Important:
In order to use SSL, it is necessary to enable SSL version 3 only in the
Telnet client software.
page_1_1_14_3
Contents
|
77