PRIMERGY BX600 S3 Hardware Manual page 84

Chapter 5 CLI
●
2. System Power Supply (1_3_2)
Displays the state of the power supply.
+------------------------------------------+
|
+------------------------------------------+
(1) System Power Supply Control
(-) System Power Supply Status
(-) System Power Supply Redundancy
(4) System Power Supply Unit Table
(5) System Power supply Redundancy Mode: 3+1
Enter selection or type (0) to quit:
❑: Parameter
Parameter
1. System Power Supply Control
System Power Supply Status
System Power Supply
Redundancy
4. System Power Supply Unit
Table
84
System Power Supply page_1_3_2
Setting
❑
power on Sets the main power supply of the chassis.
❑
Hard Power off When using refer to "6.2 Points to Note about Remote
❑
graceful Power OFF and the Shutdown Function" ( p.139).
shutdown and off • power on
Turns on the main power supply of the chassis.
• Hard Power off
Turns off the main power supply of the chassis.
• graceful shutdown and off
"graceful shutdown and off" in "1. Server power" in
"● 1. Server Blade Control Information (1_4_1_1)"
( p.97) is ordered for all the installed Server Blades
and the power is turned off.
Important:
- Displays the status of the overall power supply.
- Displays "yes" when the power supply is redundant and
"no" when not redundant.
- Displays a list of the PSUs installed.
"• 4. System Power Supply Unit Table (1_3_2_4)"
(p.85)
|
: Hard Power off
: not-ready
: yes
Contents
When using this function it is necessary to
make various settings to the installed Server
Blades. For details, refer to "6.2 Points to
Note about Remote Power OFF and the
Shutdown Function" ( p.139). Do not select
this when performing operations for Server
Blades that are not supported, because there
is a fear that unexpected operations such as
ACPI shutdown or power off may occur.