PRIMERGY BX600 S3 Hardware Manual page 95

Parameter
2. NIC Detection Timeout
If an error is detected by "NIC Status Detection", the status of the Management Blade will become
"critical" but the management error LED will not blink or light up.
●
10. Turn on/off all server blades (1_3_10)
Sets the power supply of all the installed Server Blades.
+--------------------------------------------+
|
+--------------------------------------------+
(1) Turn on all server blades
(2) Turn off all server blades
Enter selection or type (0) to quit:
Parameter
1. Turn on all server blades
2. Turn off all server blades
When performing Server Blade power setting in this section, after ordering power ON/OFF, check in
the CLI display etc. that all power ON/OFF operations have been completed and move on to the
next operation.
PRIMERGY BX600 Management Blade Hardware Guide
Setting
❑
0 – 300
Note:
Set the timeout of server monitoring software such as ServerView
to a time longer than that of the "NIC Detection Timeout". For
details about setting timeout, refer to the manuals attached to the
server monitoring software products.
Turn on/off all server blades
The power supply of all the installed Server Blades is turned on sequentially.
Select and the "Confirmation" screen appears. Select "Yes, turn off all Server
Blades" and "off" or "graceful shutdown and off" will be ordered sequentially
for the "Server power" of all the installed Server Blades. For details about
"Server power", refer to " 1. Server power" ( p.98).
Contents
Sets the time (seconds) for NIC status detection. If
communication does not take place in the setting time
here, a NIC status self diagnostic test is performed.
|
page_1_3_10
Contents
95