PRIMERGY BX600 S3 Hardware Manual page 41

Display/Parameter
Sync Mode
The Lastest Sync
Date/Time
If an incorrect IP address is entered, time synchronization cannot be performed.
When NTP has been enabled, always check whether the time synchronization is being
performed in "The Latest Sync Date/Time". Because straight after setting, it sometimes
takes time to display this, click the frame reload button a few times and check display.
• SSL
SSL settings are performed on the SSL page. SSL version 3 is supported.
Display/Parameter
HTTP SSL
Telnet SSL
In order to use SSL, it is necessary to enable SSL version 3 only in the Web browser
and terminal emulator. Also, if SSL version 2 is enabled in the Web browser, set to
disable.
• Duplex Mode
Transmission rate settings are performed on the Duplex Mode page.
Display/Parameter
Setting Mode
PRIMERGY BX600 Management Blade Hardware Guide
Specifies the time synchronization mode.
• Sync Afterward
The time of the Management Blade is synchronized to the time of the NTP server
only when the time of the NTP server is fast. When using this for operations that
demand time to be taken into careful consideration such as databases, select this
mode.
• Sync Always
The time of the Management Blade is synchronized with the NTP server every
15 minutes.
This displays the last time at which Management Blade and NTP server time
synchronization was performed.
Sets whether HTTP SSL is to be used.
• enable: use HTTP SSL
• disable: do not use HTTP SSL
Sets whether Telnet SSL is to be used.
• enable: use Telnet SSL
• disable: do not use Telnet SSL
Sets the transmission rate.
• Auto-Negotiation: auto-negotiation
• 100 Full Mode: 100Mbps full duplex secure
• 100 Half Mode: 100Mbps half duplex secure
• 10 Full Mode: 10Mbps full duplex secure
• 10 Half Mode: 10Mbps half duplex secure
Description
Description
Description
41