PRIMERGY BX600 S3 Hardware Manual page 40

Chapter 4 Web UI
• Domain Name Server
Domain Name Server (DNS) is set on the Domain Name Server page.
Display/Parameter
DNS Server 1
DNS Server 2
• HTTP
Port number is set on the HTTP page.
Display/Parameter
Port
• Telnet
Port number and Drop Time settings are set on the Telnet page.
Display/Parameter
Port
Drop Time
• NTP
The enabling/disabling of settings and NTP server settings are performed on the NTP page.
Display/Parameter
NTP
Local NTP Server 1
Local NTP Server 2
40
Sets the IP address of the primary DNS server.
Sets the IP address of the secondary DNS server.
Sets the port number of the HTTP interface.
Default value:80
Changes to port settings will make valid 10 seconds after the changes.
Sets the port number of telnet.
Default value:3172
Sets the amount of time (secs) until a hibernating Telnet connection automatically
disconnects.
This can be set within the range of 30–65535 seconds. If set to 0 the automatic
disconnection function is disabled.
Also, the set value will be the same as the "Management Agent Timeout (Sec)" on
the CLI.
The change to the Telnet port number becomes valid after rebooting the Management
Blade.
Sets whether to perform time synchronization in the Management Blade using
Network Time Protocol (NTP). If NTP is enabled, the time of the Management
Blade is synchronized with the NTP server every 15 minutes.
• enable: use NTP.
• disable: do not use NTP.
Sets the IP address of the primary NTP server.
Sets the IP address of the secondary NTP server.
Description
Description
Description
Description