Table of Contents
Advertisement
4.2.6 Lan Switch Blade Group
Displays all the installed Switch Blades.
Click the link and the following information will be displayed for Switch Blades.
Click [Reload] to update the displayed Switch Blade information. However, the information is not
updated when the Switch Blade is not activated or straight after a replacement.
●
Blade Info group
Sets and displays various Switch Blade information.
Display/Parameter
Status
Located LED
Blade Information
Manufacture
Produce Date
Serial Number
Product Name
Model Name
Board Version
Firmware Version
Network Setting
Mac Address
URL Address
IP Address
Subnet Mask
Gateway Address
Apply
Reload
PRIMERGY BX600 Management Blade Hardware Guide
This section is displayed only for Cisco Catalyst Blade Switch 3040.
Displays the status of the Switch Blade.
• ok: Switch Blade is in normal status.
• Fail: IOS crash or POST error has occurred.
Sets the display of the maintenance LED of the Switch Blade. Used to identify the
multiple Switch Blades installed in the chassis.
• blinking: blinks the maintenance Switch Blade LED.
• off: will not set the maintenance Switch Blade LED.
Blade information
Displays the manufacturer.
Displays the manufacture date.
Displays the system serial number.
Displays the product name of the system.
Displays the model name.
Displays the board version.
Displays the firmware version.
Network setting
Displays the MAC address for management.
The URL of the Switch Blade Web UI is displayed.
Click the URL to jump to the page (network wiring and settings are necessary).
Sets and displays the management IP address
of the Switch Blade.
Sets and displays Switch Blade subnet masks.
Sets and displays Switch Blade gateway address.
Applies the values set in "IP Address", "Subnet Mask", and "Gateway Address" to the
Switch Blade.
Applied information is saved as a Switch Blade boot file named "backupexi".
Updates Switch Blade display information.
Description
• Current Value
Present settings are
displayed.
• Setting Value
After entering the new
settings, click [Apply] and
settings are set to the Switch
Blade.
49
Advertisement
Table of Contents
