Cli Connection Methods - PRIMERGY BX600 S3 Hardware Manual

Chapter 5 CLI

5.1 CLI Connection Methods

This chapter explains CLI connection methods using Telnet via LAN or a serial
interface.
When using CLI via LAN using Telnet it is recommended to use the following
software.
• RemoteControlService V3.06 or later
5.1.1 Using Serial Interface
1
Connect Management Blade to the management terminal using an RS-232C
cross cable.
"■ Serial Interface Settings" (p.18)
2
Start the terminal software in the management terminal and perform the
following port settings.
Parameter
Bits/sec.
Data bit
Parity
Stop bit
Flow control
3
Sets the terminal software of the management terminal to [VT100].
For more details about how to set terminal software, refer to the manual supplied with the
terminal software.
64
Connect the Management Blade operating in master mode.
A Management Blade in slave mode cannot be accessed.
Check the operation mode of the Management Blade with the Management Blade
master display LED ( "1.2 Component Names and Functions" (p.11)).
115200
8
None
1
None
Setting